Me collecting my kit from Extreme!!

Day 3 - More Stripdown

Firstly, remove the seat belt securing nut. to do this
just pull off the adjuster handle with a tug....

This reveals the screw that secures the plastic cover

Plastic cover removed, the seat belt can now be

unbolted

Now remove the adjuster slider metal by removing the 2
bolts.

This now reveals the 2 bolts that hold the rear quarter
window on...

Remove these using a magnet to catch them, after this,
the windows just comes off when the catch is removed

Door cards next..Remove this bolt

Then pull off the door handle surround

Remove this plug....

then remove this bolt...

and this one, then "pop" the door card off, then remove
the inner rain shield from the door

You need to remove this bolt to remove the outer door
trim, this then reveals a hole so that you can now
remove the two glass rear securing bolts, after that
remove the two glass front securing bolts from inside
the door, you can now remove the glass.

Then remove the passenger handle, coat hooks, interior
lights and then the sun visors. A big tip, the two
connectors on the left are for the visors, if you
unplug these you will then be able to remove the sun
visors without cutting the wires like I did :-(

Then remove the headlining....

I also then removed all the wiring and wire securing
clips from the A pillars and the roof.

Thought I would just hang the door on like everyone does!! :-)

Thats it for today......

Day 2 - more stripdown

remove the panel next to the accelerator

next, remove the inner sill cover

removed...

Add caption

Remove the door seal

Remove the rear panel by removing this screw

another screw is hidden behine this plug

its hard to see, but you need to remove it with the screwdriver at this angle!!

One more small screw holding it on in the sill

loosen the rear quarter window seal (cant remove until window
catch is removed...

Rear panel can now be removed, this is what that awkward screw
looks like

Remove the rear window catch by unscrewing the 3 screw
holding it on, you can then remove the window seal

I removed this part hanging down under the rear bumper on
the drivers side - anyone know what it is?

Day 1 - Stripdown!!

Remove this panel from both sides

Removed!!

Remove this bumper locking bar from both sides, the other nut is at the other end!

Headlights are a pain!! this nut was very rusty!

Release these 3 nuts at the front of the car

Bumper, headlights and a metal tie bar that hold the radiators
now removed

Remove the mud shields from both sides

unbolt the wing...very simple this bit!

...and the other side

Front end stripped!!

Boot lid removed

Rear mud shields removed from both sides

Rear seats removed to allow the boot side and floor carpet to
be removed

Rear lenses removed, all wiring marked up and labelled so I
dont forget where its from!!

Rear bumper off!!